基于粗糙遗传算法在打捆机齿轮箱故障诊断中的应用*

自走式连续作业打捆机是一款实现不停机连续打捆作业的新型秸秆收集装备,其关键功能部件齿轮箱发生故障会严重影响正常打捆工作。针对齿轮箱故障的防控和监测,提出一种结合粗糙集和遗传算法的故障诊断方法。该方法使用时域频域分析得到的多项故障特征参数作为条件属性,故障类型作为决策属性,并利用自适应遗传算法得到决策规则表,实现无需先验信息的属性约简和故障诊断。在齿轮箱故障诊断试验中,分别对不同故障类型进行信号采集和诊断分析,结果显示:该方法在无先验信息的条件下将12项故障特征参量约简为3项,根据决策规则表进行故障诊断的准确率为100%,结果表明该方法能准确判断故障的发生和故障类型,对实现故障监测和防控具有重要意义。     

Impact of high temperatures on the marketable tuber yield and related traits of potato

A rapid warming of 2.8–5.3 °C by the end of this century is expected in South Korea. Considering the current temperature during the spring potato growing season (emergence to harvest; ca. 18 °C), which is near the upper limit of the optimum temperature for potato yield, the anticipated warming will adversely affect potato production in South Korea. The present study assessed the impact of high temperature on the marketable tuber yield and related traits of cv. Superior (which makes up 71% of the annual potato production in South Korea) in four temperature-controlled plastic houses and an outdoor field (37.27°N, 126.99°E) during 2015–2016. The target temperatures of the four plastic houses were set to ambient (AT), AT+1.5 °C, AT+3.0 °C, and AT+5.0 °C. The marketable tuber yield was significantly reduced by 11% per 1 °C increase over a temperature range of 19.1–27.7 °C. The negative impact of high temperature was associated not only with the yield loss of total tubers, which was mostly explained by the slower tuber bulking rate, but also the reduced marketable tuber ratio under temperatures above 23 °C, which was mainly attributed to the reduced number of marketable tubers (r = 0.79***). Under moderate temperatures below 23 °C, the source limited the number of marketable tubers without reducing the marketable tuber ratio. In contrast, the number of marketable tubers was limited by the marketable tuber set at the early growth stage rather than the source under the higher temperatures, which resulted in the reduction in the marketable tuber ratio below 56%. These results suggest that the objectives of breeding and agronomic management for adapting to the rapid warming in South Korea should include maintaining the ability to form tubers at the early growth stage under high temperatures, as well as the photosynthetic capacity and sink strength of the tubers.     

水泵机组状态监测与故障诊断系统研究

从20世纪60年代到21世纪，我国的泵站工程为输水、供水以及防洪减灾提供了有力保障。针对水泵机组的状态监测与故障诊断进行研究，建立水泵机组状态监测与诊断的软件及各分析模块与数据库，进行机组性能的预测研究，为水泵机组的状态维修提供支持。     

Artificial reef placement: a red snapper,Lutjanus campechanus,ecosystem and fuzzy rule‐based model

Abstract This study on reef placement involves two aspects: (1) the development of a bioenergetics model for red snapper, Lutjanus campechanus (Poey), in Gulf of Mexico waters off the coast of Alabama, where significant numbers of artificial reefs are thought to exist, and (2) a fuzzy rough set model by which parameters determined from the bioenergetics model can provide a decision tool for optimally spacing artificial reefs during deployment. The bioenergetics and consumption rates of L. campechanus by age class foraging on artificial reefs in the Gulf of Mexico off the coast of Alabama provided input into the fuzzy rule‐based model. After conducting multiple simulations, highest certainty in optimal reef spacing was achieved for reef distances between 0.50 and 0.95 km such that no more than two fit within a 1‐km² area. Results can inform fisheries managers about placement of artificial reefs to affect the health and survival of reef‐associated species.     

油初始坐果机制研究

以成年油木奈树为材料,对其初始坐果进行了研究。结果表明,盛花后2周内,油木奈出现大量的落花落果;幼果(子房)低水平的GA1 3与油木奈的落花落果高峰关系密切,而内源细胞分裂素ZRs和[diH]ZRs以及ABA与幼果(子房)的生长呈显著的正相关;初始坐果期,油木奈的雌配子体发育缓慢,且有相当数量的胚囊中途退化、败育,无法正常受精,从而导致其大量的落花落果。文中就油木奈的初始坐果机制进行了讨论。     

Pollen and pollination experiments. I. the contribution of stray pollen to the seed set of depetalled,hand-pollinated flowers of apple

Summary Using the finger nails to remove most of the petals is a fast method of preparing apple flowers for hand pollination in the balloon stage. Such flowers still appeared quite attractive to insects; left to open pollination, the seed set per flower averaged two thirds of that of similarly treated, but hand-pollinated flowers. With the aid of marker pollen of scab or mildew resistant donors and the subsequent screening of the seedling progenies for resistance, it was shown that the stray pollen was responsible on average for one of every three seeds formed by unbagged depetalled and hand-pollinated flowers.     

Factors affecting haploid production in wheat using the Hordeum bulbosum system. 3. Post-fertilization effects on embryo survival

Summary An investigation was made of factors affecting the frequency of development of fertilized ovules following wheat x Hordeum bulbosum hybridizations. Seed survival, a term used here to represent the relationship between seed set and fertilization, was shown to vary between the wheat genotypes tested, but was unrelated to the crossability genes present within the wheat genotype. A high seed survival was obtained in crosses involving the variety TH3929 and the single chromosome substitution line, Chinese Spring (Hope 5B). Chinese Spring showed a poor seed survival. Some influence of the H. bulbosum genotype on seed survival was detected. The two environmental factors studied, namely the post-pollination application of gibberellic acid and the ambient temperature, were both shown to affect seed survival. The application of gibberellic acid immediately after pollination or 1 and 2 days after pollination improved seed survival, although the extent of the response was dependent upon the number and timing of the application(s). A genotype-dependent response to the ambient temperature was observed, TH3929 showing a slight but insignificant reduction and Chinese Spring a significant improvement in seed survival with an increase in temperature from 20°C to 26°C. The physiological processes which may be influenced by GA and the ambient temperature and may thereby affect seed survival are discussed.     

Seed set and seedling variation in greater yam (Dioscorea alata L.)

Summary A high degree of fruit and seed set was obtained in Dioscorea alata L. by hand pollination. The sexual progeny was studied in comparison with the clonal plants. In general, the seedlings were poor in growth vigour, flowering and tuber production but the variations observed in the different characters were unprecedented, indicating scope for efficacious genetic improvement in this vegetatively propagated crop.     

基于水平集和先验信息的农业图像分割方法

提出了一种基于先验信息的C-V模型并对杂草、小麦、苹果进行分割研究.根据某类农业图像的特点,把图像表示为易于分割的模型,提取模型中感兴趣目标的信息量作为先验信息,通过H分量得到初始轮廓,并以此初始化提出的模型,迭代求解水平集函数,得到收敛的目标轮廓曲线.对杂草、小麦、苹果分割结果统计分割面积正确率为0.999、0.999、0.846,面积错误率为0、0、0.125.     

A review of the effect of stresses between lifting and planting on nursery stock quality and performance

This paper presents the experimental evidence on the effects of desiccation, low and high temperatures, rough handling, root loss and storage between lifting and planting on plant quality and performance. The review concentrates on the impact of these stresses on outplanting performance; their effect on seedling properties, such as root growth potential and root electrolyte leakage, is also described. Stresses most often happen in combination but there is relatively little information on their interactions. Examples of desiccation plus rough handling, cold storage plus desiccation, frost damage plus freeze storage and the triple stress of desiccation, heating and rough handling are presented. The limited evidence on the cumulative effect of stresses suggests tentatively that damage from rough handling does not accumulate in the same way as damage from desiccation and prolonged storage. Factors affecting stress resistance are briefly reviewed.There are three impediments to producing a critical review of the literature: experimental treatments, particularly of desiccation and rough handling, can rarely be directly compared; the impact of stress treatments can be modified by a large number of factors, and the levels of stress have seldom been quantified in normal forestry practice. The first two problems also make it difficult to formulate general statements concerning critical thresholds for the stresses. However, instruments are now available for measuring and monitoring stresses between lifting and planting and it is, in theory, possible to model the effects of these stresses to take account of the many factors that modify their impact on seedling survival and growth. This offers the possibility of significant improvements in our ability to predict the effect of stresses between lifting and planting on seedling performance.